|
|
 |
|
 |
|
 |
|
 |
|
 |
|
 |
|
 |
|
|
|
|
|
 |
|
 |
|
 |
|
 |
|
 |
|
 |
|
|
|
| PANEL INSTALLATION GUIDE
TOC > BEFORE YOU START >
WALL PANELS > DON'T OVERNAIL
How to Work with Wall Panels Don’t over-nail your panels! The heads of your nails should just depress the OSB so the top of the nail head is flush with the outside OSB. Be careful not to compress the foam insulation and reduce panel thickness, especially at your corners.
Figure 10a. Cut your panel edge angles with circular saw beam-cutter attachment
Figure 10b. Drill for nails, then pre-nail your panels on the ground to control nail spacing and angles - proper nail control prevents damage to your timbers |
|
Copyright © 2001-2004 by R-Tight® Stress Skin Panel. All rights reserved. |
