|
|
 |
|
 |
|
 |
|
 |
|
 |
|
 |
|
 |
|
|
|
|
|
 |
|
 |
|
 |
|
 |
|
 |
|
 |
|
|
|
| PANEL INSTALLATION GUIDE
TOC > BEFORE YOU START >
WALL PANELS > PANEL LAYOUT
How to Work with Wall Panels Pay careful attention to the panel layout we sent you. In some places you’ll have to use ‘scraps’ from one panel to piece in another location. Don’t throw any panel pieces away until you’re done, and be careful to keep the panel pieces covered and dry. See Figure 12 for piecing panels. Important: Don’t throw any panel pieces away until you’re all done! Keep your panel pieces covered and dry. You might need them in another place on your frame. In places you might need to apply panels horizontally. This works just as well as vertical paneling. See Figure 13 and Figure 31 for examples of this.
Figure 12. Trim and save panel scraps to use in another location - refer to your panel layout
Figure 13. You can use a horizontal piece of panel to fill in |
|
Copyright © 2001-2004 by R-Tight® Stress Skin Panel. All rights reserved. |
