|
|
 |
|
 |
|
 |
|
 |
|
 |
|
 |
|
 |
|
|
|
|
|
 |
|
 |
|
 |
|
 |
|
 |
|
 |
|
|
|
| PANEL INSTALLATION GUIDE
TOC > BEFORE YOU START >
ROOF PANELS > VALLEY
How to Install your Roof Panels If your frame has valley systems, you’ll need to cut a compound angle into your panels where they rest in the valley. This is similar to cutting the ridge angle, but in reverse. Again, leave a 1/4" space in the valley to allow for expanding foam sealer (see Figure 21). Test cut and fit some small panel scraps to check your saw angles and bevels before working with full-sized panels. Do not nail panels into the valley timber itself - it’s easily damaged!
Figure 21. Details of panels in valley system |
|
Copyright © 2001-2004 by R-Tight® Stress Skin Panel. All rights reserved. |
